Filter
Top Products
Note: The power supply returns are connected to the
chassis, so you cannot isolate logic common
ground from chassis ground.
Power Cable Connector
The tape drive operates from standard +5 VDC and +12
VDC supply voltages; it cannot use external AC power.
Safety agency certification requires that the supplied
voltage be from a Safety Extra-Low Voltage source (per
IEC 950). Refer to Appendix B for tape drive power
specifications.
CAUTION
The tape drive does not provide any overvoltage or
over current protection. For this reason, be certain
that the power is off before connecting the tape
drivetoapowersupply.
The power connector used in the tape drive is compatible
with power connectors used for standard 5.25-inch
devices. To connect the tape drive to a power cable, use
an AMP 1-480424-0 series or equivalent female connector.
For information about the specific power connector pin
assignments, refer to the EXB-8500 and EXB-8500c Product
Specification.
December 1993 EXB-8500/EXB-8500c 43