Frymaster EWBS Cooktop User Manual


 
3-6
SETTING THE UNIT UP FOR FIRST-TIME OPERATION
Before turning the cooker on, ensure that:
the unit is connected to the water supply.
the water supply is turned on.
the unit is plugged into an appropriate outlet.
the electrical power supply is turned on.
CAUTION
It is recommended that the simmer setpoint and the cook/stir times for all 10 products be
programmed before the unit is first used in a cooking cycle.
When the unit is tested at the factory, the simmer setpoint and product cook times are programmed.
These test settings are not default settings. You must program the unit for your own particular
products. Program the setpoint and all 10 product cook/stir times as follows:
1. Turn the computer on by pressing the Power Switch.
2. Enter the programming mode by pressing the Program Mode Switch . CodE appears in
the left display. If you enter the programming mode by mistake, press the switch again to
exit the programming mode.
NOTE: If you try to enter the programming mode while the computer is cooking, the display
will flash BUSY.
NOTE: The unit comes from the factory configured to display in degrees Fahrenheit. To
toggle back and forth between Fahrenheit and Celsius, press the Program Mode switch,
then enter the code
1 6 5 8
by pressing the corresponding product buttons. Next, press
the Temperature Check/Program Lock
switch to lock in the new display option.
3. Enter the number 1 6 5 0 by pressing the corresponding product buttons. Unless this
code is entered, programming will not be accepted. This is to prevent unauthorized changes
to your current instructions.
4. SP-r (Setpoint) will appear in the left LED display. Any previously programmed
temperature setpoint will appear in the right display. To change the setpoint, enter the
desired setpoint temperature using the corresponding product buttons. The setpoint can be
programmed for any value up to 212°F (100°C). Press the Program Mode
switch to lock
in the new setpoint (or the old setpoint, if it was not changed).
5. SELP (Select Product) will appear in the left display. Press the product button to be
programmed (or press to return to the normal operating mode).
6. COOC (Cook Time) will now show in the left display. Any previously programmed
cooking time will appear in the right display. Pressing
will accept the current cooking
time. To change the cooking time, enter the new time using the product buttons. The cook
time can be programmed up to 59:59. Press
to lock in the new time.