Filter
Top Products
2-48
ITEM PART # COMPONENT
1 807-2484 Valve, Solenoid Vent
2 810-1372 Elbow, 90º x ¼-inch NPT x ⅜-inch Tube
* 811-0932 Vent Tube, Teflon, ⅜-inch O.D. per foot
3 809-0601 Clip, Rod End Clevis
4 Shaft, Rear Flush Valve
810-1767
For use in left oil return valve assemblies (see illustration below).
810-1766
For use in right oil return valve assemblies (see illustration below).
5 Handle, Rear Flush Valve
901-2772
For use in left oil return valve assemblies.
902-2772
For use in right oil return valve assemblies.
6 813-0165 Elbow, 90º x ½-inch Street
7 813-0022 Nipple, ½-inch Close
8 810-0278 Valve, ½-inch Ball
* 900-2935 Nut, Oil Return Valve Retainer
* 810-1003 Valve, ½-inch 180º 3-way Ball
9 806-9828SP Flexline Assembly, 9-inch Oil Return
10 813-0469 Cap, ½-inch Pipe
11 810-1360 Manifold, KFCH250 Rear Flush Oil Return
12 810-1357 Manifold, KFCH350 Rear Flush Oil Return
13 810-1378 Manifold, KFCH450 Rear Flush Oil Return
14 Cover, FPH50 Rear Flush Oil Return Microswitch
901-2214
For use in left handle and switch assemblies.
902-2214
For use in right handle and switch assemblies.
15 826-1366 Nut, 4-40 Keps Hex (Pkg. of 25)
16 807-2103 Microswitch
17 810-1186 Cam, Filter System Microswitch
18 826-1377 Setscrew, 10-32 x ¼-inch (Pkg. of 25)
19 816-0220 Insulation, Microswitch
20 Handle, Rear Flush
823-2295 For use in Non-CE applications (see illustration below).
823-2259 For use in CE applications only (see illustration below).
21 812-1253SP Cover, Rear Flush Handle
NOTE: Left and right refer to the fryer as viewed from the front when facing the fryer.
Shaft 810-1767
(Note orientation of flat
and 45° angle to left.)
Shaft 810-1766
(Note orientation of flat
and 45° angle to right.)
Full Vat or
Left Side of Dual Vat
Right Side of Dual Vat
Handle 823-2295
(Note orientation of slot)
This handle is used in
non-CE applications.
NOTE: Handles are shown in
Valve OPEN/Filter ON position.
Handle 823-2259
(Note orientation of slot)
This handle is used in
CE applications.