Filter
Top Products
2-27
2.11.3 FootPrint III Square Drain Components, Standard Configuration
NOTE: The assemblies shown represent typical FP III standard
drain configurations. All components are illustrated, but there are
many other possible combinations of these components.
5
6
15
12
14
18
17
16
13
16
12
9
9
9
7
10
2
1
3
8
11
17
4
FPH250
FPH250-2R
FPH450-2L
FPH450-4R
ITEM PART # COMPONENT
1 806-6374 Clamp Assembly
2 816-0420 Boot (Connection Seal) 3 ½”
3 KIT-0257SP Clamp Assembly and Boot Kit (contains 2 of Item 1 and 1 of Item 2)
4 826-1382 Wing Nut (Pkg. of 10)
5 811-0932 Vent Tube, Teflon, ⅜” OD (FP III units manufactured after Sep 97) per foot
6 810-1372
Fitting, 90°, Vent Tube (for use with Item 5)
7 816-0135 O-Ring
8 823-2444 Left End Section, Dual Vat, 4.06” Long
9 823-2445 Left End Section, Full Vat, 7.95” Long
10 823-2231 Drain Outlet Section, Closed, 15.86” Long
11 823-2294 Drain Outlet Section, Open, Dual Vat, 11.55” Long
12 823-2223 Drain Outlet Section, Open, Full Vat, 23.38” Long
13 823-2225 Drain Section, Dual Vat, 11.55” Long
14 823-2301 Drain Section, Full Vat, 15.39” Long (Hole on Rt. 823-2316)
15 823-2193 Drain Section, Left End, Dual Vat, 3.57” Long (stud left of center)
16 823-2212 Drain Section, Right End, Dual Vat, 3.57” Long (stud right of center)
17 823-2221 Right End Section, Dual Vat, 4.06” Long
18 823-2198 Right End Section, Full Vat, 7.89” Long
* 806-8408SP Drain Assembly FPH350 w/out Rear Flush
* 806-8414SP Drain Assembly FPH 450 w/out Rear Flush