Filter
Top Products
Page 48
Part # MCOSM06 Rev 1 (11/03/08)
MOTOR
To Replace Convection Oven
Motor Assembly
1. Open doors and remove all oven racks.
2. Remove 4 #10 sheet metal screws (that secure the air
bae) and remove air bae.
3. Remove six hex nut 1/4-20x7/16" (2A) and lock washers
(4A) from the motor mounting studs.
4. Place a piece of cardboard on the oven oor to protect
from scratching or chipping.
5. Pull the entire motor assembly (1A) away from the rear
oven wall into the oven cavity and place on cardboard.
6. Disconnect wiring, be sure to note wire locations.
7. To reinstall reverse the above procedure.
1A
4A
2A