Filter
Top Products
03/09/09 P/N 4523367 Page 13
13) Install New Burner
Ensure that the bracket at the tip of the burner locks onto the bracket attached to the
oven floor. No screws are necessary for this procedure.
The burner may not stand up perfectly by itself. The installation of the oven orifice later
will correct this problem.
New burner and pilot assembly installed
14) Reinstall Both Front Shields
Install the right side shield first, guiding the various pieces of tubing and wire as shown in
the below photograph. This setup will allow for an easier installation for the safety valve.