Filter
Top Products
03/09/09 P/N 4523367 Page 16
17) Reinstall Igniter Bracket
Refer to Step 3 for igniter bracket connections
18) Attach Main Burner Gas Line Flex Tubes onto Valve
Two brass fittings (Part 7, Assembly Drawing) should already be installed on the Main
Burner gas inlet and outlet on the Baso valve. Otherwise, they are included in the kit
separately for service personnel assembly.
Unscrew the free end of each fitting to release the nut and ferrule. Install these on one
end of each 7/16” flex tube (Part 2, Assembly Drawing) and attach the tubes to the Main
Burner gas inlet and outlet on the Baso valve. See picture below for details.
Nut and ferrule unscrewed from fitting on valve, installed on one free end of each 7/16” flex tube