Filter
Top Products
03/09/09 P/N 4523367 Page 15
16) Reinstall Door Springs
Refer to Step 4 for door spring connections
For the door hinge with no microswitch:
Hook on one end of the spring to the hooks from the orifice bracket
Place a screwdriver underneath the opposite end of the spring and pry upward to
hook that end onto the bell crank assembly.
Left: Setup screwdriver at end of spring underneath hook on bell crank assembly
Right: Screwdriver pried upward, locks spring into place
Pry the bell crank assembly upward to hook on the oven door hinge link. This is the
same as the uninstalling procedure in Step 4
For the door hinge with a microswitch:
Install the spring and hook on the oven door hinge link using the same method as
outlined above
Screw on the microswitch bracket. Ensure that the button on the microswitch is
pushed down once the bracket is screwed on. Any other position will break the
switch when the door is opened
Left: INCORRECT. Button is not depressed when bracket is screwed on
Right: Correct installation with depressed button.