Filter
Top Products
15
For safety, push the side rails into the grill
chamber.
The side rails can be removed to make cleaning
the grill chamber easier by unhooking them
from the grill chamber sides.
Slides can be wiped clean with a soft cloth and
mild detergent.
use any abrasive substance.
put the side runners in the
dishwasher.
When you have finished, hook the side rails
back on to the sides of the chamber. To refit
the frame pull the side rails forward and for
each side in turn, support the side rail and
press the frame down into the side rails.
Replace the grill pan.
For best results liquid detergents should be
used.
The control panel and control knobs should
only be cleaned with a soft cloth wrung out in
clean hot soapy water - but take care that no
surplus water seeps into the appliance. Wipe
with a clean dampened cloth then polish with
a dry cloth. The oven doors should only be
cleaned with a soft cloth wrung out in clean
hot soapy water.
Uncoated natural brass is used as part of the
authentic finish and may tarnish with age.
To regain a polished finish, these areas should
be cleaned using a proprietary cleaner such
as Brasso. Stubborn marks on the aluminium
burner rings can be removed using a similar
cleaning material. This will also restore the
polished finish.
The shelf supports on the oven sides can be
removed for cleaning.
First remove the oven shelves then pull the
top of the shelf support up and away from the
oven side and then lift the support away from
the locating bracket in the oven side at the
bottom.
To refit the side support, first
locate the tag at the bottom
of the support in the slot in
the locating bracket in the
oven side.
Then locate the tops of the
side arms in the holes at the
top.
The panels on the oven sides are fixed and
cannot be removed. They have been coated
with special enamel that partly cleans itself.
This does not stop all marks on the lining, but
helps to reduce the amount of manual cleaning
needed.
The Cook & Clean panels work better above
200°C. If you do most of your cooking below
this temperature, occasionally remove the shelf
supports and wipe the panels with a lint free
cloth and hot soapy water. The panels should
then be dried and the oven heated at 200°C
for about one hour. This will ensure the Cook &
Clean panels are working effectively.