Filter
Top Products
31
f) Fit the replacement and re-assemble parts in
reverse order. Check that the oven operates
satisfactorily.
Disconnect the appliance from the electricity supply.
a) Remove oven inner back (see 21).
b) Remove 2 screws from the top of the element and
1 from the bottom of the element in side the oven.
c) Lift element out carefully, disconnect the terminals
connected to the element noting their positions.
If it is not possible to disconnect the leads in this
way, pull cooker forward to gain access to the rear,
remove screws securing the electric cover to the
back sheet and remove cover and disconnect the
terminals from the rear.
d) Fit new element, and reassemble in reverse order.
e) Check that the oven operates correctly.
Disconnect the appliance from the electricity supply.
a) Pull the unit forward to access the cover boxes at
the rear of the unit. Remove the fixings that secure
the cover and lift it clear.
b) Undo the terminal connections, noting their
positions.
c) Remove the fixings that secure the bottom
element cover.
d) Undo the terminal connections, noting their
positions.
e) Remove the lower element support fixings.
f) Remove the element bracket fixings and withdraw
element.
g) Replace the element and re-assemble parts in
reverse order.
a) Open the LH oven door and undo the fixings that
secure the heat shield.
b) Remove the top element bracket fixings and
withdraw element.
c) Replace the element and re-assemble parts in
reverse order. Check that the oven operates
satisfactorily.
Disconnect the appliance from the electricity supply.
a) Pull the grill carriage forward and lift the grill pan
away from the carriage. Lift the grill carriage so
that the front roller is free of the side arm. Slide the
carriage forward on the rear roller until you can lift
it away from the side arm.
b) From inside grill compartment remove enamelled
front shield from grill roof, 2 screws and washers.
Remove 2 screws and washers securing the grill
element front support.
c) Remove the screws from the grill elements. Lift
elements out carefully, disconnect the leads from
the element terminals noting their position.
d) If it is not possible to disconnect the leads in this
way, turn off the gas supply. Remove the drawer
– lower the front roller. Pull the cooker forward
and disconnect the gas hose. Pull the cooker far
enough forward to gain access to the rear.
e) Remove the fixings that secure the rear cover and
lift it clear. Disconnect the terminals from the rear.
f) Fit new elements, reassemble in reverse order.
Check operation of grill.
a) The door bottom hinge can be adjusted to alter
the angle of the door.
b) Loosen the bottom hinge fixing screws and use
the notch and a flat bladed screwdriver to move
the position of the hinge to set the hinge position.
c) Retighten the hinge screws.
Effect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity