Filter
Top Products
2. Mconnectingto a four-wire electrical system
(mobile home):
A
Remove the screws and
tise
the
terrnind
block cover.
B.
Remove the ground strap
born
the
terminal block and from the
apptiance
frame.
Reti
the ground screw.
C. Connect the ground wire
been)
of the
copper power supply cord to the frame of
the
apptiance
with the ground screw, using
the hole in the frame where the ground
strap was removed.
%e
F~e
2.
D.
Connect the
neuti
(white) wire of the
copper power supply cord to the center
sflver
colored
terrnind
of the
terrnind
block and connect the other wires to the
outer
teds.
E.
Replace the
terrnind
block cover.
FIGURE
2
CORD.
J
To
ehate
the
hward
of reaching overheated
surface elements,
mbinets or storage spaces
should not be provided over a range.
Hcabinets are provided, the
h-d
can be
reduced by
insfig
a
rmge
hood that projects
hotiontiy
a
minimum of 5“ beyond the botiom
of the cabinets.
men
ins~g
the range between base cabinets,
refer to figure below for the
ske
of the opening
needed. Do not
sed
the range to cabinets.
CA~ON:
men
unpacking the range, do not
&scard the 4 shipping
bolb
as these are the
levehg
legs.
Ha
service cord is used, the
wd
receptacle
should be located in accordance with the
dimensions below.
~
Of Range
1
I
I
\
\
Wall
\
~
2
=’
‘~<*Note2
Dtiided
Cootiop
(40” Range)
32