Filter
Top Products
,:>::.
Questions?
.->*”
“,.-~-=
-
Use This Problem Solver
—
-.... -,
,
PROBLEM
OVEN WILL NOT
COME ON
CONTROL PANEL
LIGHTED, YET
OVEN WILL NOT
START
FOODS ARE EITHER
OVERCOOKED OR
UNDERCOOKED
“PRObE” APPEARS ON
DISPLAY
“Error” APPEARS
ON DISPLAY
POSSIBLE CAUSE AND REMEDY
● A fuse in your home may be blown or the circuit breaker tripped. Replace fuse
or reset circuit breaker.
● Unplug your microwave oven, then plug it back in.
● Make sure 3-prong
plug
on oven is fully inserted into wall receptacle.
● Door not securely closed.
● START must be touched
after
entering cooking selection.
● Another selection entered already in oven
and
CLEAR/OFF pad not touched
to
cancel it.
● Make sure you have entered cooking time after touching TIME COOK 1 & 11.
●
CLEIAR/OFF
pad was touched accidentally. Reset cooking program and touch
START pad.
●
Make sure you have entered a temperature after touching TEMP COOK & HOLD.
● Make sure you entered a code number after touching AUTO COOK or AUTO
ROAST.
● Cooking times may vary because of starting food temperature, food density or
amount of foods in oven. Touch TIME COOK
I
& 11 pad and additional cooking
time for completion.
● Incorrect power level entered. Check cookbook for recommended power level.
● Dish was not rotated, turned or stirred. Some dishes require specific
instructions. Check cookbook or recipe for instructions.
● Too many dishes in oven at same time. Cooking time must be increased when
cooking more than one food item. Check cookbook time recommendations.
● Dish not completely covered as directed during Auto Cook.
● Previous microwaving left humidity or moisture in oven, thus
Iessening
the
cooking time in Auto Cook function.
“
Certain vegetables need a standing time after using Auto Cook. Check
Automatic Cooking Guide.
● Probe not inserted properly into meat or dish when using Temp Cook & Hold
or Auto Roast functions. Check cookbook for specific instructions.
● Probe has been forgotten or not seated properly in oven wall when using Temp
Cook & Hold or Auto Roast functions.
● During Auto Cook, Auto Reheat or Popcorn program, the door was opened
before steam
could
be detected or steam was not detected in maximum time.
● No
steam
was detected by sensor within tour minutes and 10 seconds after
start of Popcorn program.
All these things are normal with your microwave oven:
● Steam or vapor escaping from
● Dimming oven
I
ight
and change
● Some TV-Radio interference
around the door.
in
blower
sound may occur while
might be noticed
while
using your
● Light reelection around
door
or
operating at power levels other
microwave oven. It’s similar to the
outer case.
than high.
interference
caused
by other small
●
Dul
I thumping sound
whi
Ie
oven
appliances and does not indicate a
is operating,
problem with your oven.
If you need more help...call, toll free:
GE
Answer
Center’
/ 800.626.2000/ consumer information service
34