Filter
Top Products
HOW DOES THIS COOKTOP COMPARE
TO YOUR OLD ONE?
Your new cooktop has gas burners. If you are used
The best types of cookware to use, plus heat-up and
to cooking with induction or other electric surface
cool-down times, depend upon the type of burner or
units, you will notice some differences when you use
surface unit you have.
gas burners,
Type of Cooktop Description
Gas Burners
I Rewlarorsealed
*
gas-burners use
(J
either
LP gas
or natural gas.
Radiant
Electric coils
(Glass Ceramic)
under a
glass-
Cooktop
ceramic cooktop.
o
Induction
$g;f$
./,
,,,\.\,...
High frequency
induction coils
under a glass
surface.
Electric Coil
Flattened metal
e
tubing containing
electric resistance
wire suspended
over a drip pan.
Solid Disk
Solid cast iron
0
disk sealed to the
@
cooktop surface.
The following chart will help you to understand the
differences between gas burner cooktops and any
other type of cooktop you may have used in the past.
How it Works
Flames heat the pans directly. Pan flatness is not critical to cooking results, but
pans should be well balanced. Gas burners heat the pan right away and change
heat settings right away. When you turn the control off, cooking stops right away.
Heat travels to the glass surface and then to the cookware, so pans must be flat on
the bottom for good cooking results. The glass cooktop stays hot enough to
continue cooking after it is turned off. Remove the pan from the surface unit if
you want cooking to stop.
Pans must be made of ferrous metals (metal that attracts a magnet). Heat is
produced by a magnetic circuit between the coil and the pan. Heats up right away
and changes heat settings right away, like a gas cooktop. After turning the control
off, the glass cooktop is hot from the heat of the pan, but cooking stops right away.
Heats by direct contact with the pan and by heating the air under the pan. For best
cooking results, use good quality pans. Electric coils are more forgiving of
warped pans than radiant or solid disks. Heats up quickly but does not change
heat settings as quickly as gas or induction. Electric coils stay hot enough to
-
continue cooking for a short time after they are turned off.
Heats by direct contact with the pan, so pans must be flat on the bottom for good
cooking results. Heats up and cools down more slowly than electric coils. The
disk stays hot enough to continue cooking after it is turned off. Remove the pan
from the solid disk if you want the cooking to stop.
SUREACE COOKING
Electric Ignition
Your surface burners are lighted by electric ignition,
Surface burners in use when an electrical power
eliminating the need for standing pilot lights with
failure occurs will continue to operate normally.
constantly burning flames.
In case of a power failure, you can light the surface
burners on your range with a match. Hold a lighted
match to the burner, then turn the knob to the LITE
position. Use extreme caution when lighting
burners this way.
Surface Burner Controls
Knobs that turn the surface burners on and off are marked as to which
burners they control. The two knobs on the left control the left front and
left rear burners. The two knobs on the right control the right front and
right rear burners.
10