GE JGSP30 Range User Manual


 
.
Clock
The clock must be set for the automatic oven timing
functions to work properly. The time of day cannot
be changed during a Timed Baking or Self-Cleaning
cycle.
To Set the Clock
c1
1. Press the CLOCK pad.
CLOCK
n
2.
Press the
INCREASE or DECREASE
A
padtosetthetirneof
day.
~
Timer
To Set the Timer
The timer is a minute timer;
it does not control oven operations.
The maximum setting on the timer
c1
1. Press the TIMER
The timer will start automatically
TIMER
ON/OFF pad.
ON/OFF
within a few seconds of releasing
the pad. The timer, as you are
is 9 hours and 55 minutes.
setting it, will display seconds until
n
2. Press the INCREASE
1
minfite
is reached.”Then it will
A
or DECREASE pad
display minutes and seconds until
~
to set the amount of
60 minutes is reached.
time on the timer.
After 60 minutes, it will display
hours (“HR” now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.
To Reset the Timer
To Cancel the Timer
If “TIMER” is displayed, press the INCREASE or
Press and hold the TIMER ON/OFF pad until the
DECREASE pad until desired time is reached.
word “TIMER” disappears from the display.
If “TIMER” is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Cycle Tone
Display Messages
The end of cycle tone is a series of 3 beeps followed
If “door”
appears
in
the display,
the door is open.
by 1 beep every 6 seconds. If you would like to
Close the door. If “LOCK” appears in the display, the
remove the signal that beeps every 6 seconds, press
oven door is in the locked position. BAKE, BROIL
and hold the
CLEAWOFF pad for 10 seconds.
and COOK TIME cannot be set if the door is in the
To return the signal that beeps every 6 seconds, press
locked position.
and hold the CLEAR/OFF pad for 10 seconds.
Power Outage
After a power outage, when power is restored, the display will flash and
time shown will no longer be correct-for example, after a 5-minute power
interruption the clock will be 5 minutes slow.
All other functions that were in operation when the power went out will
have to be programmed again.
13
I