Filter
Top Products
Proper care and cleaning are important so your range
BE SURE ELECTRICAL POWER IS OFF
will give you efficient and satisfactory service. Follow
BEFORE CLEANING ANY PART OF THE
these directions carefully in caring for your range to
RANGE.
assure safe and proper maintenance.
Burner Assembly
The burner assemblies should be washed regularly
and, of course, after
spillovers.
Turn all the controls to OFF before removing the
burner parts.
The electrode of the spark igniter is exposed
beyond the top of the burner. When cleaning
the burner bowl, be careful not to snag the
electrode of the spark igniter with your cleaning
cloth. Be careful not to turn on any cooktop
controls while cleaning the burner bowls. A
slight electrical shock might result which could
cause you to knock over hot cookware.
The burner grates, burner tops and trim rings can be
lifted off, making them easy to clean. Removing them
gives you access-to the burner bodies and burner
bowls. (To avoid snagging cloth on spark igniters,
ieave
burner tops in place when cleaning burner
bowls.) There is a locating pin
tliat
fits into an
indentation at the bottom of the bowls. The pin allows
the grate to sit level in one direction only. Do not
remove the pin. Do not remove the burner bowls
from glass top units. Clean the burner grates, caps,
and bowls with abrasive cleaners or soap filled steel
wool pads. Soak stubborn soil. Dry them with a
cloth—don’t reassemble them wet.
To reassemble: Place the trim ring onto the burner
body first. Before replacing the burner top, first
examine the two tabs on its underside. The tabs are to
fit into receiving slots in burner head. When replacing
burner grate, make sure the bottoms of the four larger
burner grate fingers fit into the corresponding
indentations in the burner bowl.
.
I
Burner
ToP
#—T’mRing
:1-1
~
Burner Bowl
CAUTION: DO NOT OPERATE THE
BURNER WITHOUT ALL BURNER PARTS
IN PLACE.
(continued next page)
29