Operating the Self-Cleaning Oven
Before Setting Oven
Controls, Check These
Things:
Step 1:
Remove broiler pan, broiler rack
and other cookware from the oven.
(Oven shelves may be left in oven.
Note: Shelves will discolor after
the self-clean cycle.)
Step 2:
Wipe up heavy soil on oven bottom.
A. Oven Front Frame
B. Oven Door Gasket
C. Openings in Door
D. Oven Light
Step
3:
Clean spatters or spills on oven
front frame (A) and oven door
outside gasket (B) with a dampened
cloth. Polish with a dry cloth. Do
not clean gasket (B). Do not allow
water to run down through openings
in top of door (C). Never use a
commercial oven cleaner in or
around self-cleaning oven.
Step 4:
Close oven door and make sure
oven light (D) is off.
How to Set Oven
for Cleaning
Step 1:
TurnOVENSETandOVEN
TEMPknobsto CLEAN.
Controls
will snap into final position when
the CLEAN location is reached.
Step 2:
Slide LA’_KH HANDLE to the
right as far as it will go.
3:00, CLEAN TIME and OVEN
DOOR LATCHED appear on
display.
The oven is programmed to clean
for 3 hours but you may change
clean time by touching CLEAR
pad and number pads to enter a
different clean time from 1%to
4% hours.
“E EE” appears on display if you
enter a clean time less than 1
Y2 or
more than 4% hours.
-Y
3
.
Step 3:
To begin cleaning immediately,
touch START. Display shows stop
time—in this example, 3 hours from
the time cleaning operation starts.
No other fimction of the Conventional
Oven can be used until the self-
cleaning cycle is over and the oven
door is unlatched. You may use
the Microwave Oven during
cleaning time.
N~E: Fan in Microwave Oven
comes on when the lower oven
door is latched and
START is
pressed. You’ll
know cleaning has .
started when the Cleaning light
glows. The fan will stop when the
cleaning cycle ends.
To delay start of cleaning:
Step 1:
Repeat steps 1 and 2.
Step 2:
Touch STOP TIME pad and number
pads for the time of day you want
cleaning to be finished.
Display shows the time you
programmed oven to stop cleaning,
STUP CLEAN TIME and OVEN
DOOR LATVHED.
38