Filter
Top Products
❑
~KGUMD
lHfiMWTIOH
1. Place backguard assembly into position on
the black
pedesti
at rear of range.
backguard
bolts are attached to bottom of backguard by
means of flat nuts.)
2. Bolt backguard to range with nuts. Tighten
nuts snugly. Nuts are in small envelope in
pack-
out carton.
(&cure
bac~ard
braces,
if
equipped.)
3. Insert the backguard. Disconnect plug “A”
(if equipped) from range. Disconnect plug and
wdl
cord
‘Bn.
anifold
Pipe
Do not set the range over holes in the floor or
other
lomtions where it may be subject to strong
drafts. Any opening in the
w~
behind the range
and in the floor under the range should be
sealed. Make sure the flow of combustion or
ventilation air is not obstructed.
Left side of range
~
Location for
hardpipe
20V.
connection
to range
O
24”
2
Recommended gas hook-up locations behind range. Gas fitting:
and shut-off cock should not protrude more than
2X” from wall
to allow range to fit against wall.
27