Filter
Top Products
SMACE
COO~G
Lighting Instructions for Electric Ignition Models
JGAS02EN
The surface burners on some models
me
lighted by
electric ignition, eliminating the need for standing pilot
The electrode of the spark igniter is exposed.
lights
witi
constandv
burning
flames.
men
one burner is turned to
LITE,
W
tie
burners
-
In
me
of a power failure, you can light the surface
spark. Do not attempt to disassemble or clean
burners on your range with a match. Hold a
hghted
around any burner while another burner is on.
match to the burner, then turn the knob to the
L~
An electric shock may result, which could cause
msition. Use extreme mution when
ti~hti
burners
you to knock over hot cookware.
I
I
hs
way.
--
Surface burners in use when
an
electrical power failure
occurs will continue to operate normally.
Lighting Instructions for Standing
mot
Models
JGAS02PN,
JLAS02PN
The surface burners on these ranges have standing
pilots that must be
tit
initially. To light them:
1. Be sure surface burner control knobs are in the
0~
position.
-
2. Remove the grates and lift the
cooktop
up (see the
Cooktop
section).
3. Locate the 2 pilot ports
ad
light each of them with
a match.
pilot
adjustment
%
screw
&
4
pilot
tubes
2
\
pilot
filter
manifold
7
manifold
panel
pipe
4.
If the pilots need adjusting, turn the adjusting screw
located on the pilot filter.
5. Lower the
cooktop.
Your surface burners are now
ready for use.
6. Observe lighted burners. Compare the flames to
pictures in the Problem Solver. If any flame is
unsatisfactory,
crdl
for service.
Surface Burner Controls
Before Lighting a Burner
The knobs that turn the surface burners on and off are
●
If drip pans are supplied with your range, they
located on the control panel on the front of the range.
should be used at
dl
times.
The two knobs on the left control the
lefi
front and
left rear burners. The two knobs on the right control
●
Make sure
dl
the grates on the range are in place
the
right front and right rear burners.
before using any burner.
8