Filter
Top Products
❑
IF
WGE
WfiMDING
~LOW
LIGHT
MD
WJUST
SURWE BURNER
PILO~
1. Purge
dl air from supply system by turning
one top burner valve
fu~y
ON for 15 seconds.
2. Turn valve OFF and
fight
pilot burners.
Adjust pilot flames using adjusting screw at the
manifold pipe, so that each flame is
approtiately
l/4inch
in height.
3. To
fight
any top burner, push and turn burner
knob to the
fite
position.
4.
men
burner has ignited, rotate knob to
desired flame setting.
Surface
Burner Pilot
(If equipped)
~
,/
k
1/4.
Approx.
Pilot Flame
<
Pilot Adjustment Screw
Mantiold
Lefi
Pilot
Pl~
Right Pilot
d
❑
IF
WGE
W
ELECTRIC lGHITION–
There are separate ignition devices for the left
and right
had
surface burners. Both of these
igniters are ON when any knob is turned to the
L~
setdng.
The igniters
wi~
“spark” as long as
any of the top burner knobs are at the
~
setting.
h
the event of an electrical power failure, the top
burners
m
sti~
be used. To
fight
a burner, hold
a
hghted
kitchen match adjacent to the top
burner to be used and turn valve knob to
HTE.
USE
E-ME
CA~ON.
❑
OVEN PILOT ~JUSTMEHT
On pilot models remove thermostat knob.
Check position of
pflot
gas selector to make sure
selector is turned to the correct position for the
type of gas that is to be used. To change to
L~
insert
sd
blade screwdriver in slot and turn
fu~y
counterclockwise so that indicator points to
LPG.
To change to NAT, turn fully clockwise so
that
indimtor
poinb
to
NAT
●
H
desked,
the
@
to
the
oven
pflot
-
be
turned off
by
tur~
the selector so
the
pointer is at
the
0~
position,
mid-
between the
WG
and NAT
se-s.
@ermostat
on your
-e
may not appear
ma
as shown in
-.)
●
On electric
i~tion
models
the
es
to the
oven burner
-
be turned off. A
manti
shut-off
-e
is provided on manifold pipe.
31