Filter
Top Products
Coil
Sutiace
Unit Module
Clean the area
sumunding
the surface uniti
according to either the Brushed Chrome or Porcelain
section (depending on your model).
To clean the surface
uniti,
turn the control to the
highest setting for a minute. The coils will bum off
any soil.
CA~ON
● Be sure
d]
controls are turned to OFF and
surface units are cool before attempting to
remove them.
●
Do not immerse the surface units or the module
in liquids of any kind.
●
Do not clean the surface units or the module in
a dishwasher.
●
Do not bend the surface unit plug
terrninds.
●
Do not attempt to clean, adjust or in any way repair
the plug-in receptacle.
Sudace
Unit
Dtip
Pan
To remove a surface unit:
To remove the drip pans for cleaning, the surface units
must be removed first.
Lift the surface unit about 1 inch above the drip pan
and
ptil
it out.
Do not tift the surface unit more than 1 inch. If you
do, it may not lie flat on the drip pan when you
plug it back in.
Repeated
~ng
of the surface unit more than 1
inch above the drip pan can permanently damage
the receptacle.
To replace a surface unit:
●
Replace the drip pan into the recess in the
eooktop.
Make sure the opening in the pan lines up with the
receptacle.
●
Insert the
terminrds
of the surface unit through the
opening in the drip pan and into the receptacle.
●
Guide the surface unit into place so it rests
everdy.
Drip Pans
Remove the surface units. Then lift out the drip pans.
-
For best results, clean the drip pans by hand.
Plaa
them in a covered container (or a plastic bag)
with 1/4 cup ammonia to loosen the soil. Then scrub
with a soap filled scouring pad if necessary.
Rinse
with clean water and polish with a clean soft cloth.
The drip pans may
dso be cleaned in the dishwasher.
Do not cover the drip pans with foil.
Using foil so close to the receptacle could cause
shock
fire or damage to the
cooktop.
Clean
the area under the drip pans often.
Built-up soil, especially grease, may catch on fire.
—
30