Filter
Top Products
Safety Instructions
Operating Instructions
Care and Cleaning Troubleshooting Tips Consumer Support
After a Clean Cycle
You may notice some white ash
in the oven. Wipe it up with a damp cloth
after the oven cools.
If white spots remain, remove them
with a soap-filled steel wool pad and rinse
thoroughly with a vinegar and water
mixture.
These deposits are usually a salt residue
that cannot be removed by the clean cycle.
If the oven is not clean after one clean
cycle, repeat the cycle.
■ You cannot set the oven for cooking
or another self-clean cycle until the oven
is cool enough for the door to unlock.
■ While the oven is self-cleaning, you can
touch the CLOCK pad to display the time
of day. To return to the clean countdown,
touch the SELF CLEAN HI/LO pad.
■ If the racks become hard to slide,
apply a small amount of cooking oil
to a paper towel and wipe the edges
of the oven racks with the paper towel.
How to Delay the Start of Cleaning
Touch the SELF CLEAN HI/LO pad
once for a 5-hour clean time or
twice for a 3-hour clean time.
A 3-hour self-clean time is
recommended for use when cleaning
small, contained spills. A self-clean
time of 5 hours is recommended
for a dirtier oven.
If a time other than 5 hours or
3 hours is needed, use the number
pads and enter the desired clean time.
You can change the clean time to
any time between 3 hours and 5 hours,
depending on how dirty your oven is.
Touch the DELAY START pad.
Using the number pads, enter
the time of day you want the clean
cycle to start.
Touch the START pad.
The upper and lower oven doors lock
automatically. The display will show
the start time. It will not be possible to open
the oven doors until the temperature drops
below the lock temperature and LOCKED
goes off in the control display.
When LOCKED goes off, you will be able
to open the doors.
ge.com
The oven doors must be closed and all controls set correctly for the cycle to work properly.
21