Filter
Top Products
Before you call for service…
Consumer Support Troubleshooting Tips Care and Cleaning
Operating Instructions
Safety Instructions
30
Problem Possible Causes What To Do
“Crackling” or This is the sound of the • This is normal.
“popping” sound metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking Excessive soil. • Touch the CLEAR/OFF pad. Open the windows to
during a clean cycle rid the room of smoke. Wait until LOCKED goes off.
Wipe up the excess soil and reset the clean cycle.
Oven door will not Oven too hot. • Allow the oven to cool below locking temperature.
open after a clean cycle
Oven not clean after Oven controls not properly set. •See the Using the self-cleaning oven section.
a clean cycle
Oven was heavily soiled. • Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
“LOCKED” flashes The self-clean cycle has been • Close the oven door.
in the display selected but the door is not
closed.
“LOCKED” is on The oven door is locked • Touch the CLEAR/OFF pad. Allow the oven to cool.
when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
“F—and a number You have a function error code. • Disconnect all power to the oven for
or letter” flash at least 30 seconds and then reconnect power.
in the display If the function error code repeats, call for service.
“LOCKED” appears The controls have • See the Control Lock section to unlock.
in the oven display been locked.
Control signals after You forgot to enter a • Touch the BAKE pad and desired temperature or
entering cooking time bake temperature or the SELF CLEAN HI/LO pad and desired clean time.
or start time cleaning time.
Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is in the • See the Special features of your oven control section.
black-out mode.
Display flashes Power failure. • Reset the clock.
Unable to get the Oven control pads were • The BROIL HI/LO and BAKE pads must be touched
display to show “SF” not touched properly. at the same time and held for 3 seconds.
“Probe” appears This is reminding you to • Enter a probe temperature.
in the display enter a probe temperature
after plugging in the probe.
Troubleshooting Tips