Filter
Top Products
This feature will aid the operator in the event there is a power
outage. If the control is timing down and the power supply
is interrupted for any reason, the control will not reset to the
original cook cycle time, When power is restored, the control
will resume timing at the point the power was interrupted,
allowing the operator to know what time is needed to finish
cooking that particular’ load of product.
The unit has a boil out mode which is factory pre-programmed.
To enter the boil out mode, follow the instructions below.
1. Place keyswitch in the COOK position.
2. Depress the SELECT PRODUCT switch and select either
IDLE or MELT.
3. Depress the TIMER switch.
4. Display will read Y for yes or N for no.
5. If you desire to enter the boil out mode, depress the switch
below Y. Control will heat to factory’s pre-programmed boil
out temperature.
6. If, for any reason, you do not wish to enter boil out
mode, depress the switch under N.
7. After boil out is complete, turn power switch to the OFF
position and drain contents from unit.
R TO CLEAN. Leave
lid open. Water under pressure is super heated and will
cause severe burns if it comes in contact with skin.