Filter
Top Products
The following checks are performed with the wall cir-
cuit breaker closed and the main power switch in the
“ON” position. Extreme caution should be taken. Make
connections before applying power, take reading, and
remove power before removing meter leads, or elec-
trical shock could result.
1. Re-apply power to unit and turn power switch “ON.”
2. Using illustrations from previous page, check voltage as
follows:
Test Points
Heat Contactor
from terminal 34 to 35
from terminal 35 to 36
from terminal 34 to 36
Results
The voltage should read
the same at each
terminal.
Primary Contactor
from terminal 27 to 28
from terminal 28 to 29
from terminal 27 to 29
It should correspond to
the voltage rating
stated on the data plate
If either contactor is defective it must be replaced as follows:
Remove electrical power supplied to the cookpot to be
worked on, by unplugging or opening the wall circuit
breaker, or electrical shock could result. Be aware that
the other controls will have power.
1. Remove only those wires directly connected to the contac-
tor being replaced. Label the wires.
2. Remove the two mounting screws on the base plate and
remove contactor.
3. Install the new contactor and tighten the two mounting
screws.