Filter
Top Products
18
4. Operation Panel Layout
The operation panel is mounted
on top of the unit (wash compartment exit side) and is
connected to the CN5 connector on the control board.
5. Features
a) Display
This operation board uses an LED display to show system details and diagnostic
information.
b) Service Menu and Error Log
A service menu ("01" to "19" and "21" to "25") allows for viewing and setting of system
operating details and parameters. See "II.F.7. Service Menu and Error Log."
c) Error Codes
Error codes ("A1" to "A3," "H1" to "H6," "L1," "L2," "b1," "b2," "o1," "o2") are designed to
protect the unit. These codes give information or warnings in the event the unit is operating
out of acceptable parameters. See "III.B. Error Codes."
6. Controls, Adjustments, and Lamps
a) Water Temperature Lamps
Light up to indicate the water temperature shown in the display.
b) "AUTO FILL" Lamp
Flashes during the auto fi ll cycle, and goes off at the end of the cycle.
"READY" Lamp
"AUTO FILL" Lamp
"WASH" Lamp
Up Button
Down Button
Display
"CHANGE" Button
"ON/OFF" Button
Water Temperature
Lamps