Filter
Top Products
56
E. Removal and Replacement of Conveyor
1) Remove the 4 bolts (2 at rear, 2 at both sides) securing the rear rack rail.
2) Hold the conveyor, and lift off the rear rack rail.
3) Take out the conveyor.
4) Remove the left and right frames from the conveyor.
Slider
• Push out the wider side
• Face the reinforcing rib side down
Roller
Frame
Rack Rail
Conveyor
Frame
Conveyor
Rack Rail
Frame
Roller
Hook
Bearing
Remove nuts
5) Remove the 5 nuts each of the conveyor rails to
release the hooks and the bearings.
6) To replace, reverse the above procedure.
Note: Be careful of the slider direction when fi tting
the conveyor on the crankshaft slider.
7) Adjust the reed switch position.
8) Make a trial run, and check for water leaks.
Reed Switch
< Front View >
Align the end of reed switch
to the center of hole