Filter
Top Products
55
D. Removal and Replacement of Gear Motor
1) Use the “ON/OFF” button on the operation panel to turn off the unit, then turn off the
dishwasher and booster tank power supplies. Lockout/Tagout to prevent the power
supplies from being turned back on inadvertently.
2) Remove the front panel.
3) The gear motor is located behind the control box and at the rear left side of the
machine compartment (JWE-2400CUA-L-25B) or located at the rear right side of the
machine compartment (JWE-2400CUA-R-25B).
4) Disconnect the gear motor wiring at the closed end connectors.
5) Remove the bolts securing the bracket to the unit base and the nuts securing the
bracket to the wash tank.
6) Loosen the 2 hexagon socket set screws for the coupling.
7) Slide up the coupling, and remove the gear motor together with the bracket.
8) Remove the gear motor from the bracket.
9) To replace, reverse the above procedure.
Note:
1. Fit the coupling securely on the gear motor shaft.
2. Apply a thread sealant to the hexagon socket set screws, and tighten them
securely.
3. Align the gear motor shaft with the crankshaft from the wash tank.
4. Be careful not to mix up the wire colors.
10) Make a trial run, and check for water leaks.
Flinger
Coupling
Hexagon Socket
Set Screw
Gear Motor
Bolt
Bracket
Nut
Bracket
(Wash Tank)