Filter
Top Products
IntelliCarb Training Manual
Publication Number: TP01071 - 6 - © 2004, IMI Cornelius Inc.
Ice Drink Model ED150/175/300 Coldplate Cover
FIGURE 9
Ice Drink Model ED200/250 Coldplate Cover
FIGURE 10
3. Total Flex System for Ice Drink Models ED150/175/200/250/300
Total Flex Manifold (Insulation Removed)
FIGURE 11
Total Flex is a system of water manifold blocks located at the front of the cold plate, adjacent to the cold
plate inlets, for easy switch over of carbonated / non-carbonated beverage drinks. The right hand mani-
fold block is for the beverage valves located to the right side of the ice chute, and the left block is for the
left bank of valves. Each beverage valve on the dispenser can be set up for either carbonated or non-car-
bonated drinks. Refer to the unit’s plumbing diagram for the factory carbonated / non-carbonated valve
locations. The procedure for switching carbonated / non-carbonated water lines on a beverage valve is
as follows:
A. Shut off the water supply to the dispenser. Depressurize and drain both the carbonated and non-
carbonated water circuits.
B. Remove the retainer clip (2 screws) from the manifold block. Switch the plug and water line fitting
to their respective carbonated / non-carbonated outlet locations on the block.
C. Replace the retainer clip. Turn on the water supply and energize the “switched” valve(s). Check
for water leaks.
4. Important: Route the dispenser’s drain line to an open drain with the end of the tube above the flood
level of the drain. The drain line must pitch downward and contain no “traps”.
5. Connect both the carbonator pump and motor unit and the dispenser to a grounded
electrical sup-
ply outlet.
Liquid Level Probe
CO
2
Check Valve with Ground Stud
In-line CO
2
Check Valve
Ground Plate/Stud
Probe
Plugs
Retainer Clip
Water Line
Manifold Block