Filter
Top Products
13 91704
MAINTENANCE
REGULAR BASIS (or as required)
Cleaning of the ice maker is recomm ended on a regular basis not only for sanitary reasons, but also to maintain
the perf ormance of the unit. Build-up of line and scale can hinder ice-making production rates and interfere with
proper dispensing of the ice. See Cleaning Instructions for t he recommended procedure.
EVERY THREE MONTHS (or as required)
It is recommended t hat the air inlet filt er be cleaned every three (3) months or sooner depending on the operat-
ing environment f or proper refrigeration system per formanc e. On an ai r-cooled unit, al so che ck that the con-
denser is free of dirt/foreign material that could cause air flow blockage. Consult the Maintenance/Adjustmen t
Procedures section for cleaning these items.
PE R IODICALLY (or as required)
Check t he vending area sink for proper water drainage. Remove any foreign material from the sink to prevent
drain blockage.
CLEANING INSTRUCTIONS
IMPORTANT: The ice maker should be cleaned at a minimum of three (3) month interval s or more
frequently, depending on local water conditions. The storage hopper i nterior should be cleaned once
a
month.
CAUTION: Do no t use metal scrapers, sharp ob jects or abrasives on the surface of the
storage hopper, as damage may result. Do not use solvents or other cleaning agents, as
they may attack the plastic surface. Use only the recommen ded chemical s and soluti ons for
both the ice maker and hopper.
Ice Maker Section
1. Open the hinged service door on t he upper left side panel.
2. Put the “Stop/Run ”switch in the “stop”position at the end of th e ha rvest cycle. An alternate method would
be to stop the unit during th e ice-making cycle and al low ice in the evaporator to melt by waiting for at least
1 hour before beginning the cleaning procedure. The “Flush”switch can be depressed t o bring in warmer
water to help the melting process.
W ARNING: The unit is stil l pl ugged into the electrical po wer du ring the ice maker section
cleani ng. To avoid possible injury, do not reach into ho pper, or into ice maker nozzle. Do
not contact exposed electrical wiring or components.
3. Close the water supply valve t o the ice m aker.
4. Remove the ice drop cover from the evaporator and the storage hopper cover.
5. Seal the evaporator outlet with the plastic plug provided with t he unit and replace the ice drop cover.