Filter
Top Products
1491704
6. Move the water float valve reservoir to the “Clean”position by lifting slightly and pulling forward to raise the
reservoir to the upper m ounting screws.
7. Remove the float valve cover and add 4 ounces of Virginia Ice Machine Cleaner to the reservoir.
CAUTION: Virgin ia Ice Machine Cleaner is a mild acid, therefore normal care sho uld be
taken when using. Keep out of eyes and cuts. Read warnin gs on package befo re usin g. Do
not operate unit in the clean ing mode without the ice drop cover in place. There may be
some overflow of cleaning solutio n through the evaporato r vent tube during the cleaning cycle.
8. Open the water supply valve and fill evaporator with water (level is up in float reservoir).
9. Put t he “Clean/Run” switch in t he “clean”position. Allow unit to run in the cleaning mode for at least 30
minutes.
10. Put t he “Clean/Run” switch in t he “run”position.
11. Close the water supply valve.
12. Depress t he “Flush”switch push but ton and drain evaporator for about 1-1/2 m inutes. Release push but-
ton. Open the water supply valve. Allow evaporator to refill with water. Repeat St eps 11 and 12 three (3)
times to thoroughly remove cleaning solution f rom evaporator.
13. Close the water supply valve. Depress the “Flush”switch push button for 1-1/2 minutes t o drain the evapo-
rator.
14. Lower the float valve reservoir to “Run” position. Remove the evaporator plug.
15. Open the water supply valve and fill the evaporator with water.
16. Put t he “Stop/Run”switch in the “run”position and allow unit t o run through at least three (3) complet e ice
making cycles or until ice is fre e of “sweet”taste.
W ARNING: If unit fails to harvest ice, put the “Stop/Run ” switch in the “stop” position.
Close the water supply valve. Depress the “Flush” switch push button for 1-1/2 minutes to
drain the evaporator. Flu sh the evaporator with hot water to thorou ghly melt all the ice in
the evaporator. Repeat Step 12 to remove all traces of the cleaning solution from the evaporator.
17. Dispense all ice out of storage hopper and discard.
Dispenser Section
1. Turn off the main electrical power supply to thr machine.
2. Remove the agitator assembly from storage hopper and wash and rinse it thoroughly.
3. Wash down all inside surfaces of the ice storage area, including the top cover and ice drop cover with a
mild
detergent solution and rinse thoroughly to remove all traces of detergent.
4. Replace the agitator.
5. Remove ice chute cover as follows:
A. Flex sides outward to disengage lower pins.
B. Lift ice chute cover to disengage upper pins.
C. Lower Ice Chute cover down out of unit . Note: It may be helpful to twist cover slig htly.
6. Clean the inside of the ice chute, and ice chute cover with a mild
detergent solution and rinse thoroughly to
remove all traces of detergent.