Filter
Top Products
3291704
HARVEST TIME ADJUSTMENT
W ARNING: Disconnect electrical power to the unit befo re servicin g the timer in the
electrical box.
1. Disconnect power to ice maker.
2. Remove upper front panel and electrical control box cover.
3. Place the “Stop/ Run”switch in the “Stop”position.
4. Using Figure 9 a s a guide, set t he timer cam tabs as follows, start ing with cam wheel No.1 (all cam tab
positions are in relation to No.1 left cam tab).
NOTE: Timer cam wheels can be manually rotated only i n the normal direction of rotation-downward as
viewed from the front of the unit.
A. “Manually”adjust the cam tabs by using each “click”as the cam t ab is rotat ed, as equivalent to .75
seconds.
B. Set up cam wheel No.1 with the left and right cam tabs back-to-back as shown in Figure 9A.
C. Adjust the cam tabs on wheels No. 2 through No. 5 in sequence as shown on the chart. Rotate t he
cam wheels manually downward to set each wheel.
D. After the cam tabs are manually set, reconnect power to the ice maker.
E. Rotate the cam wheels slightly to activate the timer motor (No. 1 tell-tale down).
F. Using a stop watch, time the cam switch tell-t ales. Adjust the cam tabs as necessary for the required
cycle times.
MANUAL FILLING
In t he event t hat the ice maker is not functioning, the hopper may be m anually filled with ice.
1. Open the hinged service door.
2. Place the “Stop/ Run”switch in t he “Stop”position.
W ARNING: Electrical power is on to the agitator motor and the gate solenoid . Avoid
contact with these components.
3. Remove the ice drop and storage hopper covers.
4. Fill hopper with ice and replace covers. Unit is now ready for dispensing.
CAUTION: Do not use crush ed or flaked ice. Use of bagged ice, which has frozen in to large
chunks, can voi d warranty
. The agitator is no t desig ned to be an ice crusher. Use of large
chunks of ice which “jam up” inside the hopper will cause failure of the agitator motor and
damage the hopper. If bagged ice is used, it must be carefully
and completely broken into small,
cube-size pieces before filling into the storage hopper. Do not allow foreign material to enter the
ice storage hopper.