Filter
Top Products
The Installation, page 3 of 5
7. Make Plumbing Connections
10
With all of the components secured in place, the tubing connections can be made.
When routing the tubing between components, several guidelines should be observed:
•Tubing runs should generally follow the contour of the cabinet rather than interfere
with the cabinet storage area.
•Arrange the tubing so that there are no sharp bends. Leave
some extra length in the tubing for ease of servicing, then cut
tubing to the desired length.
• Insert tubes completely into all quick-connect fittings to
the stop (minimum depth of 1/2").
•The polyethylene tubes can be cut, but caution should be
exercised to ensure that a clean (burr-free) cut is made
perpendicular to the tube.
Completely insert 3/8"
polyethylene tubing into
inlet side of filter head.
Completely insert 3/8"
polyethylene tubing into
outlet side of filter head.
Completely insert
dispenser faucet copper
tube (marked with white
tape) into the quick-
connect union fitting.
Model GN1100
Completely insert 3/8"
polyethylene tubing from
outlet side of filter head
into 3/8" to 1/4 quick-
connectunion fitting.