Filter
Top Products
Parts & Components
In general, you'll be installing a faucet above-sink, with a filter assembly and a heating
unit below-sink.You'll also be connecting all of the plumbing. Under the sink you'll
need a grounded electrical service outlet, a connection to the cold water line (not
included), and enough space to install the filter and tank assemblies.
1. Dispenser Faucet (HC Model shown)
2. DuraTank
™
Hot Water Tank
3. Filter Head & Bracket Assembly
4. F-201 Filter Cartridge
5. Two 3/8" x 3' Polyethylene Tubes
6. 3/8" Brass Nut,Ferrule,and Tube Insert
7. 6" Filter Vent Tube (not shown)
8. 3/8" to 1/4" Quick-Connect Union Fitting
(for GN1100 models)
or 3/8" to 1/4" Quick-Connect "Y" Fitting
(for HC1100 Models)
9. Dispenser Faucet Mount O-Ring, Clamp
Plate,6 mm Nut and Installation Tool
10. Tank Mounting Bracket and Screws
Here's what a typical complete installation should look like when you're done:
Note:Component placement should be such to avoid electrical outlet.
5
SinkTop™ Switch
sold separately.
For Reference Only
10.
4.
3.
5.
1.
2.
9.
6.
8.