Filter
Top Products
9. Fill the Tank
Turn on the water supply. Push the dispenser’s HOT handle and
hold it to fill the tank.
Nothing will happen until the tank fills up and water begins
coming out of the faucet.The water will be cold because the
TANK IS NOT PLUGGED IN.
Run the faucet for 3 minutes to flush the filter before initial use.
The Installation, page 4 of 5
8. Connect to Cold Water Supply Line
Supplied with the unit is a brass nut, ferrule and
tube insert to connect the polyethylene tube
from the input side of the filter to a standard 3/8"
compression fitting. Other plumbing connections
are possible – check with a qualified plumber
should you have questions.
Slide the nut and ferrule over the tube and then
push in the tube insert. Insert the tube into a
standard 3/8" compression fitting (not supplied)
and tighten. Be careful not to over tighten.
Note:Connect the filter to the cold water supply only.
11
Model HC1100
To remove a tube from its quick-connect fitting,
depress the release ring into the fitting and gently
pull the tube away from the fitting.
Completely insert 3/8" polyethylene tubing from outlet side of filter head into 3/8"
to 1/4" quick-connect "Y" fitting. Completely insert both dispenser faucet copper
tubes (marked with white tape and unmarked) into the quick-connect "Y" fitting.