Filter
Top Products
Once you have made the adjustment, actuate the dispenser
handle for 20 seconds and allow the water to re-heat at the
new temperature setting. If the temperature is still too hot or
too cold, continue to make slight adjustments. At no time
should the water in the tank be allowed to boil. Boiling is
indicated by water and/or steam discharged from the faucet
without actuating the handle.
Replace the access panel.
To Reset the Thermal Cut-Out:
In the event the unit stops heating or fails to heat the water, check the thermal cut-
out as it may have tripped. Open the access panel on the front of the tank with a
screwdriver. Locate the thermal cut-out reset button and press it to reset the switch.
Replacement Filter Guidelines: It is essential that regular filter replacement be
carried out for this product to perform as advertised. Replace the cartridge every
three months or when there is an obvious decrease in water flowing from the faucet
or when objectionable taste and/or odors return. Replace with In-Sink-Erator
®
brand
filter cartridges. Flush new cartridges for 3 minutes before first use.
Electric Shock Hazard.To prevent electrical shock, disconnect
power before servicing unit. Use only a properly grounded and
polarized electric outlet.
To Replace the Filter:
Place a pan or dish-towel under the filter to catch water drainage during the cartridge
change.
Slowly turn cartridge counter-clockwise completely until it stops (approx. 90
º
or 1/4
turn). At this position, the inlet and outlet ports have been closed and the filter’s internal
pressure has been relieved. Approximately 2 oz.of water will be discharged from the
vent line. Pull used cartridge straight out and discard.
Insert new cartridge into filter head.Top surface of cartridge will become flush with
bottom of filter head when fully engaged.Turn cartridge clockwise until it stops (approx
90
º
or 1/4 turn). If the new filter cartridge cannot be inserted, insert the old filter
cartridge and turn completely until it stops and the arrow on the head and bracket
assembly aligns with the in/out arrow on the cartridge.
Open hot water faucet to expel trapped air and allow water to run 3 minutes.
Care and Use
13