Filter
Top Products
Plumbing & Electrical Requirements
Plumbing: Be sure that any plumbing connections conform to your applicable local
codes.The water supply line pressure should be at least 30 psi (pounds per square
inch). Low water pressure can cause water to drip from the spout.
Electrical: The hot water tank should have power supplied to it at all times. It should
not be controlled by the same wall switch that operates your disposer.If the outlet
supplying power is controlled by a switch and also supplies power to another
appliance (such as your food waste disposer), the In-Sink-Erator SinkTop
™
Switch can
be used to avoid electrical wiring changes.
The SinkTop
™
Switch conveniently switches power between two electrical outlets,
which allows the hot water dispenser and food waste disposer to be connected to
the same electrical outlet. Consult your local plumbing supplier for more information,
or visit www.insinkerator.com.
Electric Shock Hazard. A standard grounded outlet within 30" of
the dispenser is required under the sink for the dispenser’s
requirements. Do not use an extension cord set with this water
heater. If no receptacle is available adjacent to the water heater,
contact a qualified electrician to have one properly installed. Size
electrical supply appropriately. Ensure that all electrical wiring and
connections conform to applicable codes.
Personal Injury. The faucet dispenses water up to 212˚F, whichcan
instantly cause scalds or burns. Use care when operating this
appliance.
Fire Hazard. To minimize possibility of fire, do not store flammable
items such as rags, paper or aerosol cans near the tank. Do not
store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
Personal Injury. This tank is a non-pressure tank. Do not modify this
system. Do not close vent tube or connect other type dispensers or
valves to the tank. Use only the dispenser faucet supplied. Use only
parts provided. Contact an authorized In-Sink-Erator Service agent
for repairs or replacement components.
7