Filter
Top Products
Tank Electrical Specifications: 750 watts, 115 volts, 6.5 amps.
With 3-wire cord and 3 prong plug provided.
Tank Capacity Specifications: 1/2 Gal: 60 cups per hour
Tank Thermostat Specifications: Adjustable from 160˚-200˚F
F201 Chemical & Mechanical Reduction Filter Specifications: (Use replacement
cartridge F-201R) This cartridge (included with the system) provides mechanical and
chemical reduction of dirt/rust, taste/odor, chlorine and particulates.
Pressure: 30-125 psi Temperature: 33˚F–100˚F
Flow Rate: 0.75 gpm Capacity: 500 gallons
Filter Capacity: 500 gallons,depending on local water conditions.Note that while the
testing was performed under standard laboratory conditions, actual performance may vary.
Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.For cold water use only.Systems must be
installed and operated in accordance with the Manufacturer’s recommended procedures
and guidelines.See warranty card for warranty.For service and parts, contact your local
dealer or In-Sink-Erator directly at 1-800-558-5700.
Application guidelines/Water Supply Parameters for NSF Testing: Service flow of 0.75 gpm, community or
private well water supply, water pressure of 30-125 psi, water temperature of 33˚F–100˚F . Except as noted,
all testing performed at pH = 7.5±0.5, Flow: 0.75 gpm, Pressure: 60 psi,Temp:20˚±3˚C.
Contact an authorized In-Sink-Erator service agent for repairs or replacement components.
Electric Shock Hazard. Using an ungrounded or improperly
connected appliance can result in serious injury or death from
electric shock.
This appliance must be grounded. This appliance is equipped with a cord having an
equipment grounding conductor and a grounding pin.The plug must be connected
to an appropriate outlet that is properly installed and grounded in accordance with
all local codes and ordinances. Please size electrical supply appropriately and check
rating plate for electrical requirements. Do not modify the plug provided with the
appliance - if it will not fit the outlet, have a proper outlet installed by a qualified
electrician. Check with a qualified electrician or serviceman if you are in doubt as to
whether the appliance is properly grounded.
System is tested and certified by NSF International
against ANSI/NSF Standard 42 for the reduction of
Particulate Class I, Chlorine Class I, Taste and Odor.
Specifications & Approvals
2.10 0.05 97% N/A 500180-00
Particulates 286667 1683 99% N/A 500181-00
4
Grounding Instructions
Contaminant
Reduction
Average
Influent ppm
Product
Water ppm
Average
Reduction
USEPA
Recommendation
NSF
TEST
Taste/Odor/
Chlorine