Jenn-Air JGS9900BD Oven User Manual


 
28 16026923 © 2006 Maytag Services
Disassembly Procedures
To avoid risk of electrical shock, personal injury or
death; disconnect power and gas before servicing,
unless testing requires power and/or gas.
Oven Door Latch Replacement
1. Remove control panel, see "Control Panel Removal"
procedure.
2. Remove screws securing door latch to the front of the
oven cavity outer shell.
3. Slide oven door latch assembly forward to diagnose.
4. Label and disconnect wire terminals from latch
assembly.
5. Reverse procedure to reinstall door latch assembly.
Oven Door Hinge Removal
1. Remove power from unit.
2. Remove unit from installation position, see “Removing
and Replacing Range” procedure.
3. Remove oven door, see "Oven Door Removal"
procedure.
4. Remove front side trim, see "Front Side Trim
Removal" procedure.
5. Remove screws securing side panel to chassis.
6. Remove the top and bottom screws securing hinge
receiver to the front frame.
7. Remove hinge receiver from oven chassis.
8. Reverse procedure to reinstall oven door hinge.
Bottom Access Panel Removal
(Select Models)
1. Grasp top of bottom access panel and gently pull
down and out.
2. Reverse procedure to reinstall bottom access panel.
Bottom Access Panel Disassembly
(Select Models)
1. Grasp top of bottom access panel and gently pull
down and out.
2. Remove screws securing front panel to glass panel.
3. Reverse procedure to reassemble bottom access
panel.
NOTE: See page 30 for illustration.
Storage Drawer Removal (Select Models)
1. Slide strorage drawer out until drawer stops.
2. Press tabs up or down (depending on side) on
storage drawer "stops" to release drawer from slide
track.
3. Slide storage drawer completely out of slide track.
4. Reverse procedure to reinstall storage drawer.
Storage Drawer Track Disassembly
(Select Models)
1. Remove storage drawer, see "Storage Drawer
Removal (Select Models)" procedure.
2. Place drawer on a protected surface.
3. Remove screws securing front panel to glass panel.
4. Remove screws front panel to storage drawer.
5. Remove screws securing "sliding tracks" to storage
drawer.
6. Reverse procedure to reassemble.
Storage Drawer Disassembly
1. Remove warming door, see "Storage Drawer
Removal (Select Models)" procedure.
2. Place door on a protected surface.
3. Remove screws securing front panel to glass panel.
4. Remove screws securing front panel to storage
drawer.
5. Remove screws securing "sliding tracks" to storage
drawer.
6. Reverse procedure to reassemble storage drawer.
NOTE: See page 30 for illustration.
Warming Drawer Removal (Select Models)
1. Slide warming drawer out until drawer stops.
2. Press tabs up or down (depending on side) on
warming drawer "stops" to release drawer from slide
track.
3. Slide warming drawer completely out of slide track.
4. Reverse procedure to reinstall warming drawer.
Warming Drawer Element Removal
(Select Models)
1. Remove warming drawer, see "Warming Drawer
Removal" procedure.
2. Remove screws securing element brackets to oven
chassis and element.
3. Remove element and slide toward front of unit.
4. Label and disconnect element wiring.
5. Reverse procedure to reinstall warming drawer
element.