Filter
Top Products
© 2006 Maytag Services 16026923 A – 3
Installation Instructions
Jenn-Air Updraft Gas Slide-In Range
INSTALLATION INSTRUCTIONS
PLEASE KEEP THIS MANUAL FOR FUTURE REFERENCE
This manual is intended to assist in the initial installation and adjustments of the range.
• Only qualified personnel should install or service this range.
• Read “Safety Instructions” in Use & Care book before using range.
• Improper installation, adjustment, alteration, service, maintenance or use of range
can result in serious injury or property damage.
• Installer, take care not to damage flooring.
Do not lift or move range by grasping door handles or main top.
This range has been designed in accordance with the
requirements of various safety agencies and complies with
the maximum allowable wood cabinet temperatures of 194˚F.
If this range is installed with cabinets that have a lower
working temperature than 194˚F, discoloration, delamination
or melting may occur.
Place range in a well lit area. Do not set range over holes in
the floor or other locations where it may be subject to strong
drafts. Any opening in the wall behind the range and in the
floor under the range should be sealed. Make sure the flow
of cooling/ventilation air is not obstructed below the range.
Note: A range should NOT be installed over kitchen carpeting.
High Altitude Notice: The specified gas burner ratings
typically apply to elevations up to 2000 feet. For higher
altitudes, the rates may need to be reduced to achieve
satisfactory operation. A local certified gas servicer will be
able to advise if a reduction is necessary.
A risk of range tip-over exists if the appliance is not installed in
accordance with the provided installation instructions. The proper use
of the ANTI-TIP device minimizes the risk of TIP-OVER. In using this
device the consumer must still observe the safety precautions as
stated in the USE and CARE MANUAL and avoid using the oven doors as
a step stool. Installation instructions are provided for wood and cement
in either floor or wall. Any other type of construction may require
special installation techniques as deemed necessary to provide
adequate fastening of the ANTI-TIP bracket to the floor or wall. The
bracket must be installed to engage the RIGHT rear leveling foot. Install
the bracket as shown in step 2.
MOBILE HOMES
The installation of a range designed for mobile home installation must
conform with the Manufactured Home Construction and Safety
Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for
Mobile Home Construction and Safety,Title 24 HUD, Part 280) or, when
such standard is not applicable, the Standard for Manufactured Home
Installations ANSI A225.1/NFPA 501A, or with local codes. In Canada
the range must be installed in accordance with the current CSA
Standard C22.1 - Canadian Electrical Code Part 1 and Section Z240.4.1
- Installation Requirements for Gas Burning Appliances in Mobil Homes
(CSA Standard CAN/CSA - Z240MH).
RECREATIONAL PARK TRAILERS
The installation of a range designed for recreational park trailers must
conform with state or other codes or, in the absence of such codes,
with the Standard for Recreational Park Trailers, ANSI A119.5-latest
edition. In Canada the range must be installed in accordance with
CAN/CSA - Z240.6.2 - Electrical Requirements for R.V.’s (CSA Standard
CAN/CSA - Z240 RV Series) and Section Z240.4.2 - Installation
Requirements for Propane Appliances and Equipment in R.V.’s (CSA
Standard CAN/CSA - Z240 RV Series).
CONNECTING THE RANGE
Electric Supply
The appliance, when installed, must be electrically grounded in
accordance with local codes or, in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70. In Canada the range must be
installed in accordance with the current CSA Standard C22.1 -
Canadian Electrical Code Part 1.
Electrical Supply Connection
The range requires 120 volts, 60 cycle alternating current from a
dedicated grounded outlet with a 15 amp circuit breaker. See serial
plate for rating, located on front frame behind storage drawer. User
may experience occasional circuit tripping if Ground Fault Circuit
Interrupter (GFCI) outlet or breaker is in use.
Electrical Grounding Instructions – This appliance is equipped
with a (three-prong) grounding plug for your protection against
shock hazard and should be plugged directly into a properly
grounded receptacle. Do not cut or remove the grounding prong
from this plug.
WARNING
WARNINGCAUTIONS
• All RANGES CAN TIP AND CAUSE
INJURIES TO PERSONS.
• INSTALL ANTI-TIP DEVICES PACKED
WITH RANGE.
• FOLLOW ALL INSTALLATION
INSTRUCTIONS.