Filter
Top Products
13
Setting Oven Controls
FOR A SILENT CONTROL PANEL
When choosing a function, a beep will be heard each time a pad is pressed. If desired, the control can be programmed
for silent operation. Press and hold
. After 7 seconds, the control will beep once. This will block the controls from
sounding when a pad is pressed. To return the sound, press and hold
again for 7 seconds until the control beeps
once.
TEMPERATURE CONVERSION
The electronic oven control is set to operate in °F (Fahrenheit) when shipped from the factory. The oven can be programmed
for any temperature from 170°F to 550°F (77°C to 287°C).
1. Press
. "— —" appears in the display.
2. Press and hold the
until "HI" appears in the display.
3. Press and hold
until °F or °C appears in the display.
4. Press the
or to change °F to °C or °C to °F.
5. Press any control pad to return to normal operating mode.
The time of day rst be set in order to operate the oven.
TO SET THE CLOCK
When the range is rst plugged in, or when the power supply to the range has been interrupted, the display will ash
"12:00".
1. Press
briey (do not hold pad down).
2. Within 5 seconds, press and hold the
or until the correct time of day appears in the display.
The clock cannot be changed during any timed bake or Self-Clean cycle.
1. Press .
2. Press the
to increase the time in one minute increments. Press and hold the to increase the time in 10 minute
increments. The timer can be set for any amount of time from 1 minute to 11 hours and 59 minutes.
If the
pad is pressed rst, the timer will advance to 11 hours and 59 minutes.
3. The display shows the timer countdown in minutes until 1 minute remains. Then the display will countdown in seconds.
4. When the set time has run out, the timer will beep 3 times. It will then continue to beep 3 times every 60 seconds until
is pressed.
The indicator light located above the
pad will glow while the minute timer is active.
The minute timer does not start or stop cooking. It serves as an extra timer in the kitchen that will beep when the set
time has run out. The minute timer can be used alone or during any of the other oven functions. When the minute timer is
in use with any other function, the minute timer will be shown in the display. To view other functions, press the pad for that
function.
While the timer is active and shows in the display, press and hold the
or to increase or decrease the time.
Press
.
To turn the display OFF or ON in the display press and hold for 15 seconds (the control will beep
once) and then release. This feature does not remove the set time of day from the memory of the control. When the
display is turned OFF the time of day will reappear for a few seconds any time the
pad is touched.