Filter
Top Products
22
to remove the xed oven vent
cover.
Figure 1
1st
2nd
3rd
Orice
holder
Electrode
Surface
Burner
Head
Surface
Burner
Cap
Surface
Burner
Grate
Any additions, changes or conversions required in order for this appliance to perform satisfactorily must be
made by Sears Service. Call 1-800-4-MY-HOME® (See back cover).
General Care & Cleaning (cont’d)
Remove in
the following order: (1st) surface Burner Grates, (2nd) Burner Caps and (3rd) Burner
Heads. Replace them in reverse order: Heads, Caps, then Grates.
Use a soap-lled scouring
pad or a mild abrasive cleanser to clean the surface Burner Caps and Burner
Heads. The ports (or slots) around the Burner Heads must be routinely cleaned. If
residue still remains in these ports, use a small-gauge wire or needle to clean the
slots or holes. For proper ow of gas and ignition of the burner—DO NOT ALLOW
SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE
GAS ORIFICE HOLDER OPENING. ALWAYS keep the surface Burner Caps and
Burner Heads in place whenever the gas Burners are in use.
To Clean the Burner Grates- The Burner Grates are dishwasher safe and may
be cleaned in the dishwasher. Remove any excessive soils before placing in the
dishwasher.
If a spill occurs on the
porcelain cooktop, blot up spill with an absorbent cloth. Rinse with a clean, damp
cloth and wipe dry. Do not use harsh abrasive cleaners on the cooktop. They can
scratch the porcelain. Completely rinse any mild cleaners used from the surface or
the porcelain cooktop may become damaged during future heating. DO NOT use
spray oven cleaners on the cooktop.
CLEANING THE COOKTOP, BURNER HEADS, CAPS & GRATES
The cooktop is designed to make cleaning easier. Because the gas Burners are sealed, spillovers are easier to clean provided
that they are cleaned up immediately.
The cooktop, Burner Heads and Caps should be routinely cleaned. Keeping the Burner Head Ports clean will prevent
improper ignition and an uneven ame. Refer to the following instructions:
Use caution when replacing the Burner Caps so the Electrodes are not damaged. This may cause a
delayed ignition or prevent the burner from igniting.
THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.