Filter
Top Products
8
Before Setting Surface Controls
ASSEMBLY OF THE SURFACE BURNER HEADS, BURNER CAPS AND BURNER GRATES
It is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates are
installed correctly and at the correct locations.
CONTROL LOCATIONS OF THE GAS SURFACE
BURNERS
Your range is equipped with gas surface burners with
dierent BTU ratings. The ability to heat food quicker and
in larger volumes increases as the burner size increases.
The small burner is best used for simmering
delicate sauces, etc. This burner is located at the right rear
burner position on the cooktop (see Figure 4).
The standard burner can be used for most surface cooking
needs. The standard burner is located at the left front
position on the cooktop (see Figure 4).
The burners are best used for bringing large
quantities of liquid rapidly up to temperature or when
preparing larger quantities of food. The POWER burners
are located at the right front and left rear burner positions
on the cooktop (see Figure 4).
Regardless of size, always select cookware that is suitable
for the amount and type of food being prepared. Select
a burner and ame size appropriate to the pan. Never
allow ames to extend beyond the outer edge of the pan.
Figure 4
1. Remove all packing tape from cooktop area. Remove all
Burner Caps and Burner Heads.
2. Discard all packing material located under Burner Heads
(if applicable).
3. To replace the Burner Heads & Caps, match the letters
located under center of Burner Caps with the letters
located inside Burner Heads (Figure 1).
4. Match Burner Skirts with Burner Heads and Burner Caps
(see Figure 1). Replace the Burner Heads and Caps on
cooktop (see Figure 2). Carefully align the Electrodes into
slot or hole of each Burner Head (Figure 3). Note: The
Burner Heads should sit at on Cooktop Burner Skirts.
5. Place the removable oven vent cover over the xed oven
vent cover.
6. Unpack Burner Grates and position on the cooktop.
REMEMBER — DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS
ORIFICE HOLDER OPENING. Always keep the Burner Caps
and Burner Heads in place whenever the surface burners are
in use.
Figure 1
Figure 2
Electrodes must
align into slot or hole for each
Burner Head
Figure 3
12.2K
9.5K
5K
14K
14.2K