Filter
Top Products
© 2007 by Stephen Beck V1.0 Page 9 of 19 Use at your Own Risk
10. Understand there are 4 wire connectors plugged into the circuit board that will need to be removed. They
are all removed in the same manner. You will want to either mark or draw a picture as to which connector
comes from what plug to make re-assembly easier. The wires are just the right lengths and naturally fit to
the proper connectors if you want to skip the pictures/labels. See Fig 7:
11. GENTLY depress the top of the lever in the middle of one of the connectors and pull the connector up off of
the PCB. You may have to GENTLY rock the connector back and forth (along the long side) to get the
connector off. (Fig. 8)
12. Repeat the above step for the rest of the connectors.
13. Understand that the PCB is held in place by a top and bottom plastic clips that can break, and the right side
tucks into a slot in the white plastic tub holding the PCB and wires. (Fig 9).
© 2007 Stephen Beck
Fig. 7
Behind
the
label
© 2007 Stephen Beck
Release Clip. All 4
connectors similar
Fig. 8
© 2007 Stephen Beck
Fig. 9
PCB hold-down clips