Filter
Top Products
12
V. ASSEMBLY
A. Top Panel and Base Pad Assembly
1. Install the four leg extensions onto the base pad using
the 1/2”-13 x 1-1/4” screws, 1/2” flat washers and 1/2”
lockwashers supplied in the Base Pad Kit. See Figure
2-6. Check that the orientation of the adjustable 6” leg
holes in the leg bottom is consistent (all to the inside
or all to the outside). The adjustable leg mounting
hole is closer to the edge of the leg than the caster
mounting hole. Install the spring clip for the oven
restraining cable to the hole in the bottom middle of
the base pad per the DETAIL A of the base pad kit
drawing (pages 6-8). This clip will attach to the
restraint cable that keeps the oven from moving too far
when installed on casters.
2. Install one caster and one adjustable 6” leg onto each
leg extension and tighten securely in place.
3. Install the lower oven cavity onto the base pad. See
Fig 2-7.
4. For single ovens ONLY:
Install the top panel using the screws included in the
base pad kit, as shown in Fig 2-8. Then, skip ahead to
Part C, Restraint Cable Installation.
For double or triple ovens:
Continue on to Part B, Stacking. Note that the top
panel should NOT be installed for double and triple
ovens until after stacking the oven cavities.
Fig 2-7. Base Pad Installation
Fig 2-6. Leg Extension and Caster Installation
Figure 2-8. Top Panel Installation
ASSEMBLED
BASE PAD
BOTTOM OVEN
ASSEMBLED
BASE PAD
BOTTOM OVEN
OVEN TOP PANEL
#10-32 X 3/4”
SC
REW
S
(
4
)