Filter
Top Products
8
ENGLISH
SECTION 2 - INSTALLATION
IV. THERMOCOUPLE INSTALLATION
1. Install one thermocouple sensing bulb into each of the two
holes in the rear panel of the oven, as shown in Figure 2-4.
Fasten each thermocouple in place using one of the #10-
32 x 3/8" screws supplied in the Installation Kit.
2. Thread BOTH sets of thermocouple leads through the
grommet and into the machinery compartment, as shown
in Figure 2-4.
3. Remove the right-side access panel of the machinery
compartment.
4. Thread the thermocouple leads through the side of the
machinery compartment as shown in Figure 2-5, and into
the electrical box (at the right-front of the machinery compart-
ment).
5. Connect BOTH sets of thermocouple leads to the tempera-
ture controller as shown in Figure 2-6. Note that the two
thermocouples are now tied together at the temperature
controller.
6. Replace the right-side panel of the machinery compart-
ment.
7. Repeat Steps 1-6 for any other oven cavities in the installa-
tion.
8=White=Positive
7=Red=Negative
R=No Connection
Ground=Shielded cable
Figure 2-4 - Thermocouple Installation Locations
Figure 2-5 - Placing the Thermocouple Leads
Figure 2-6 - Thermocouple Lead Connections
III. ASSEMBLY
A. Caster Removal
After moving the ovens in to the installation location, remove the
casters attached to each oven cavity. These casters are provided
for pre-installation movement ONLY.
B. Stacking
If the installation will include upper ovens mounted atop lower
ovens, stack the oven cavities.
C. Stands
If the installation includes ovens that are to be mounted on
stands, assemble the ovens to the stands at this time. An
exploded view of the stand is shown in Figure 2-3.
D. Flue Vent(s)
For gas ovens, attach one flue vent to the rear wall of each oven
cavity. Use one #10-16 x 3/8" and two #10-32 x 3/4" screws for
each flue vent. These screws are provided in the Installation Kit.
Figure 2-3 - Exploded View, Oven Stand
Attachment
plates inc. w/
upper oven
installation kit
Thermocouples
Grommet-protected hole