Filter
Top Products
Starting a programme
^
Select the
Start option.
The programme starts, and the prompt
Add an item shows in the display.
As long as this prompt is showing,
crockery can be added without
compromising the wash results.
A programme can only be cancelled
in the first few minutes. Otherwise
the programme must continue to the
end so that important programme
stages (e.g. reactivating the water
softener) are not omitted.
Display
The duration of the programme
selected appears in hours and minutes
in the display before the programme
begins. During the programme, the
time left until the end of the programme
is displayed.
The time displayed may vary with the
same programme. This could be due to
the water temperature at each intake,
the reactivation cycle, the amount of
crockery and how dirty it is.
When a programme is selected for the
first time, the display shows an average
time for a cold water intake.
The times shown in the Programme
chart refer to standard test loads and
temperatures.
Each time a programme is run, the
electronic unit adjusts the programme
duration according to the temperature
of the incoming water and the amount
of crockery.
To save energy, the time display
goes out after a few minutes if you do
not touch any sensors during this
time. Touch any sensor (apart from
the On/Off sensor K) to switch the
time display back on again.
Operation
38