Filter
Top Products
General problems
Problem Possible cause Remedy
The display is dark. The display has
switched off
automatically to save
energy (Standby
mode).
Touch any sensor.
Standby comes to an end.
The buzzer sounds
during a programme.
The following fault
message appears in the
display:
Salt reservoir cover
Close the salt reservoir
The salt reservoir has
not been closed
properly.
–
Close the flap to the salt
reservoir properly.
If the salt reservoir flap has
come undone during a
programme, you must:
– Switch the dishwasher off
and then back on again
with the On/Off sensor K.
– Start the programme
again.
The following fault
message appears in the
display:
Middle spray arm blocked
or
Bottom spray arm blocked
Items are blocking the
path of the middle or
the bottom spray arm.
Open the dishwasher door
and rearrange the items
which are obstructing the
spray arm.
The middle or bottom
spray arm jets are
blocked.
– Switch the dishwasher off
using the On/Off sensor K.
Then:
–
Clean the spray arm. See
Cleaning and care.
Problem solving guide
51