Filter
Top Products
Problem Possible cause Remedy
The buzzer sounds.
The following fault
message appears in
the display:
Before rectifying the problem:
–
Switch the dishwasher off
using the On/Off sensor K.
Technical fault FXX
Call Service
There may be a
technical fault.
–
First, clean the water inlet filter
and clean the drain pump and
non-return valve as described
in "Maintenance".
–
Switch the dishwasher back
on.
–
Select the programme you
want.
– Select
Start.
If the fault message appears
again, there is a technical fault.
Call the Service Department.
Waterproof fault F70
The Waterproof
system has reacted.
– Close the stopcock.
– Call the Service Department.
Fault with auto. door
closing
The door is sometimes
obstructed by an item
inside the appliance.
– If this is the case, remove the
item and switch the
dishwasher on again.
– If the same message appears
again, call the Service
Department.
Fault with auto. door
opening
There may be a
technical fault.
–
Open the door manually, and
switch the dishwasher on
again.
–
If the same message appears
again, call the Service
Department.
Problem solving guide
48