Filter
Top Products
Before using for the first time
20
Displaying and setting the water
har
dness
Open the door
.
Switch the dishwasher off with the
butt
on, if it is switched on.
Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the but‐
ton.
Keep the programme selector button
pressed in for at least four sec‐
onds until the lower right hand pro‐
gramme indicator comes on.
If this does not happen, start the proce‐
dur
e from the beginning again.
P
ress the
Short butt
on twice.
The Short
indicator will flash rapidly
twice at intervals.
The value set for the water hardness is
shown as a figur
e after in the display
(see chart).
will star
t flashing in the display.
This is the factory default setting of
15 °d.
Use the pr
ogramme selector button
to select the value which equates
to your water hardness level.
Each press on the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
The setting is now stored in memory.
Switch the dishwasher off with the
butt
on.