Filter
Top Products
Programme options
49
Buzzer tones
A sequence of audible tones will sound
at the end of the pr
ogramme or if there
is a fault.
The buzzer at the end of a programme
and warning t
ones in the event of a
fault sound 4 times at intervals with a
short pause between each set of tones.
The buzzer tones are set to off ex-
works.
If you want the b
uzzer to sound at the
end of a programme you will have to
set it. Buzzer tones for faults are always
active.
Open the door
.
Switch the dishwasher off with the
butt
on, if it is switched on.
P
ress the programme selector button
in, and whilst holding it in switch
the dishwasher on using the but‐
ton.
Keep the programme selector button
pressed in for at least four sec‐
onds until the lower right hand pro‐
gramme indicator comes on.
If this does not happen, start the proce‐
dure from the beginning again.
P
ress the
Short butt
on 4 times.
The Short
indicator will flash rapidly 3
times at intervals.
The flashing sequence in the display
shows whether the buzz
er at the end of
the programme is activated or deactiva‐
ted.
– : Buzz
er tones switched on
– : Buzz
er tones switched off
P
ress the programme selector button
if you wish to change the setting.
The setting is now stored in memory.
Switch the dishwasher off with the
butt
on.